CNC Operation (OMIO)

After you have created your CAM profile and post-processed it, it's time to actually machine the part! The following text will cover the operation of the OMIO CNC. Important: The CNC is capable of cutting thru metal, and so it is possible to seriously injure yourself and others if it is operated incorrectly. Do not operate the CNC if Mr. Shinta is not present in the room (unless he has specified otherwise). Safety glasses are a must, and you are responsible for your safety as well as anyone around the machine (So make it clear that everyone needs glasses). Supervision is required unless you have been approved to operate the CNC alone. With that, read through to learn how to use the OMIO CNC!

Using Mach3:

Mach 3 is the controller software that can be used with the OMIO. You can choose to install it on your computer or use Mr. Shinta’s Computer #15. It has Mach3 installed and configured. If you would like to install and use Mach3 on your computer, please follow the instructions in https://drive.google.com/open?id=156mGQnoUq6unnkvuyV_lM1_QziWi2jcA.

Once Mach3 has loaded, you can use the interface to control the cnc or use the USB receiver in order to use the wireless remote. In order to run an operation, use the File tab in Mach3 to Load G-Code. It will prompt you to select a file and then it will load that file. If using Mr. Shinta’s computer, you can use a USB to transfer the .tap files to the computer. The Reset button on Mach3 and the controller is the emergency stop in case anything goes wrong.

Running the OMIO:

It is very similar to the Laguna, but there are minor differences in the setup. The stock must have holes in the corners (at least as of now) so that it can be held in place on the CNC using screws. The endmills and collets for the OMIO can be found in the toolbox near the OMIO. Before running the machine, make sure the enclosure isn’t touching the stepper motors and/or any other moving parts.